Outline drawing

Customizable items: 1. Length and shape of the shaft; 2. Voltage, output speed, torque, etc. ; 3. Adding connectors, lead wires; 4. Adding gears to shaft; 5. Adding encoder.

The basic parameters are for reference

Notes: These specs are samples. Please contact us to customize your parameters.

Gearbox sheet

Selection Notes (How to Specify the Correct Version)

To receive a comparable quote and correct samples, please provide:

• Target output speed (rpm) and required output torque (g·cm / mN·m, or force + lever radius)
• Supply voltage range (battery discharge range if applicable) and any current limit
• Duty cycle (on/off time per cycle) and expected daily cycles
• End-stop behavior (soft stop vs hard stop)
• Output shaft requirement (preferred: mating-part drawing + tolerance)
  We will recommend the suitable motor length and confirm a working point aligned to your load profile, rather than relying on stall torque only.

Integration & Customization Options (Sampling to Mass Production)

Available customization items:

• Shaft length and shaft style (round, D-shaft, threaded, press-fit pinion; per drawing)
• Lead wire length, wire gauge, polarity marking
• Connector/terminal type and wire exit direction
• Encoder addition (subject to space and signal requirement)
• Speed/torque targeting via winding choice + gearbox ratio selection

FAQs

Q1. Is the plastic planetary gearbox suitable for personal care products?

It is commonly used in compact personal care actuators where lightweight design and controlled output are required. To ensure reliability, we recommend confirming the duty cycle and avoiding prolonged operation near stall torque, especially in end-stop mechanisms.

Q2. Which motor body length should we choose (12–30mm options)?

Select the length based on available axial space and required operating margin. Shorter bodies may be sufficient for light intermittent loads, while longer bodies are typically used to improve stability under higher duty cycle or higher load.

Q3. Can you supply production-ready wiring and connectors?

Yes. Lead length, connector/terminal type, polarity marking, and wire exit direction can be configured to match your harness and assembly process. Share your connector standard and layout constraints and we will align the sample build accordingly.